Axle Bits and Sockets

The axles are held on the wheel bearing end by either a single large nut or bolt. Tools for removing/installing them are in this category. The smaller bolts that hold the drive shaft to the transmission are in our Triple Square Bit Category.

View as: Grid | List (1 to 6 of 6) « Prev | Next » Display:

SubE MNDH24 - 24 mm 12 Point Socket, Impact Grade

This is the best method to rotate the engine during a V6 timing belt job and fits some front drive shaft center bolts.

$8.25

SubE Part MN227MX - 27mm 6 Point Socket, Impact Grade

This impact grade 27 mm 6 point socket is used to remove the drive shaft center bolt late model VW®/Audi®.

$8.00

SubH MN0201 - Flange Puller for 020-series Transmissions (1984~1990)

This miniature spring compressor permits the removal of tranny output flanges and replacement of the oil seal.

$20.00

SubH Part MNDH30 - 30 mm 12 Point Socket, Impact Grade

Fits most 12 point axle nuts on VW®/Audi® cars.

$15.00

SubH Part MNHB14 - 14 mm Hex Bit Socket, Impact Grade

This 60 mm long 14 mm hex bit with 1/2" square drive is used to remove the rear drive shafts from front wheel drive late model cars like 1998+ Passat® and Audi® A4.

$9.00

SubH Part MNHB17 - 17 mm Hex Bit Socket, Impact Grade

This 75 mm long 17 mm hex bit with 1/2" square drive is used to remove the front drive shafts from B5 chassis cars like 1998+ Passat® and Audi® A4.

$9.00

View as: Grid | List (1 to 6 of 6) « Prev | Next » Display:

STAY UPDATED Join our mailing list and be the first to hear all about our updates and offers!

Metalnerd.com